Solid state plug-in amplifiers that respond to flame detector inputs to indicate the presence of flame when used with 7800 SERIES relay modules.

Features

• Flame failure response time of 0.8 or 3.0 seconds.
• Flame signal strength ranges from 0.0 to 5.0 Vdc.
• Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation.
• Flame signal test jacks to measure amplifier flame signal voltage.
• Color-coded labels identify flame detection type. Dynamic Self-Check Amplifier test the detectors and all electronic components in the flame detection system 7800 SERIES relay module locks out on safety shutdown with flame detection system failure.
• Compatible with existing Honeywell flame detectors (order separately).

Product Specifications

Comments

Color: Green

Approvals, Underwriters Laboratories Inc.

Listed: File No. MP268, Guide No. MCCZ

Approvals, Canadian Standards Association

Certified: File No. LR95329-3

Customer Special

N/S

Flame Failure Response Time (sec)

2.0 sec or 3.0 sec

Approvals, Control Safety Devices

N/S

Approvals, Swiss RE

Acceptable

Approvals, Factory Mutual

Approved: Report No. 1V9A0.AF

Self Checking

None (standard)

Use With Primary Safety Control

7800 SERIES Relay Modules

Use With Flame Sensor

Gas: Rectifying Flame Rods C7004, C7005, C7007, C7008, C7009, Q179; Gas, oil, coal: Ultraviolet Flame Sensor C7012A, C